Basically there are two kinds of paints for glass that you can apply. There is water based and non-water based paint.

Hence if you opt to apply the non water based sort, you ought to use a ceramic thinner to water down the paint with. Look after your brushes however as they will have to be cleaned with a thinner, or even white spirit. They take quite a time to dry, usually perhaps more or less 2 hours, nevertheless to be completely dry anything up to 8 hours. so a bit of tolerance is needed.

If you try the water based paints which you do, in fact, dilute with water, cleaning will not be much of a problem. Your brushes etc. may dry in just about 20 minutes, but will not in reality be properly dried out possibly for days.

For your guide lines, on top of glass you want to avail yourself of an outliner, which does just that. At this point you require a firm hand as you press the paint from the tube to produce your lines. You can acquire them in a number of colour shades, nevertheless there are a few main ones one can apply. Namely black, gold, silver, along with a kind of grey.

These are probably best if you paint them on initially to mark out your actual design, or you could go over a painted surface to add some detail.

When you use the outliner I always squeeze a bit out of the tube first in case it is blocked, or has any air bubbles. It is better if you bother to keep the top clean as you go along, to stop making very thick lines.

You can what’s more use leading tape. This is more often than not used on windows and doors. Normally this comes in a couple of widths and on a roll. In this situation the backing needs to be pulled off so that you can fix the tape to the glass and then try to bend it to make your design.

Glass does want to be prepared at the outset to dispose of any grease from your surface, so that your paint will fix. You can make use of white spirit for this.

At this time when you do progress to paint within your outlines with your brush, don’t be sparing with the paint! You ought to get a good stained glass effect. If you need a paler colour and you are using a water based paint, weaken it with water.

If, though, it is a non water based paint that you are using, you can use a shiny finish varnish. You will need to use a palette for your paint. I would not recommend that you go straight from the jar as you will not like your colours to get mucky or watered down.

If you have a large space to cover you could always make use of a sponge to put on the paint moreover you could even now blend your colours whilst they are wet.

Popularity: 1% [?]